It
is a common misconception that once the Acupuncturist has inserted
the needle into the appropriate spot nothing else happens until
it is removed., not true. Once the exact site(s) has been located
the needle(s) are quickly inserted and when Qi has been obtained
(both the acupuncturist and patient will feel sensations that
confirm this) it is then the acupuncturist can decide whether
to leave the needles dormant or begin manipulation.
The needling technique used is often the personal preference of
the practitioner and what they think is suitable for the treatment
effect required.
The acupuncturist will be aware, through diagnosis, that the Qi
at a certain acupuncture point may be deficient or conversely
in excess.To address this imbalance three different approaches
may be taken.
...a. a reinforcing technique, where a deficiency needs to be
reinforced.
...b. a reducing technique, where an ecess needs to be reduced.
...c. an even technique, where the balance appears correct and
neither of the above are required.
The
needle manipulation will often vary depending on the location
of the acupuncture point, the effect required and to some extent
the personal preference of the practitioner, however they generally
will involve lifting and plunging the needle once inserted, rotating
the needle or flicking and/or stroking the needle with the finger.
These will all be of a gentle nature and something the patient
will come to recognise and accept.
|
top of page |
|
